ēno play
Install ēno play
!
Important considerations
Driver pack positioning
There is only one correct position for the ēno play driver packs that you install on the back of the
whiteboard. Determine the correct driver pack location using the template and instructions provided.
Refer to “Install the driver packs”.
Amplifier positioning
There are two optional positions for the ēno play amplifier that you install on the back of the
whiteboard. Position the amplifier in the lower left or the lower right corner
only
. Consider the
distance and routing to a power outlet and the audio input source when choosing which location to
install the ēno play amplifier. Refer to “Plan power and audio input cable routing”.
Note
: Use care when mounting the ēno play amplifier and driver packs to the back of the
whiteboard. The supplied adhesive is intended to be permanent. If you need to remove or reposition
the components, additional supplies are provided. Refer to “Removing and replacing the cable tie
holders, driver packs or amplifier”.
Power and audio input cable length considerations
Steelcase provides an audio input cable with ēno play. Determine the cable path from the ēno play
amplifier to the audio source. If the distance to your audio source is longer or considerably shorter,
obtain alternate audio input cables from a third party.
Steelcase provides a 6 ft (1829mm) power cable and a 10 ft (3048mm) extension for the amplifier.
Before installing the amplifier, consider which edge of the whiteboard provides optimum access to a
power outlet.
If installing ēno play with any of the ēno one adjustable height solutions, make sure to account for
raising and lowering the whiteboard when you determine the required cable lengths. Refer to “Plan
power and audio input cable routing”. Do not proceed with ēno play installation until you are sure
you have the appropriate cable lengths for your installation.
Cable routing options to the amplifier
The ēno play amplifier includes cable connections for:
•
two ēno play driver packs mounted to the back of the whiteboard
•
a power outlet
•
a permanent or a guest audio input source
The cable routing between the amplifier and the two driver packs is important. Cables must be
routed and secured as described in “Add cable ties and tape”.
The ēno play amplifier provides two audio input connectors: one guest connector and one
permanent connector. The guest connector faces away from the whiteboard for easy access. Refer
to “Using the guest audio input connector”. The permanent connector faces the center of the
whiteboard. Cable routing and cable management between the amplifier and a permanent audio
input source is important. Refer to “Plan power and audio input cable routing”.
4 of 23
2002480-001 Rev D
Installation and Operation Guide
