Locate brackets then drill pilot
holes with a 5/32" dia. drill bit.
2/3 HEIGHT MODESTY PANEL
attached to a MEETING or EXTENDED
BULLET WORKSURFACE or a DESK TABLE
1.
Carefully turn worksurface over onto clean, soft
surface.
2.
Refer to assembly direction # 939501982 to install
disc column.
3.
Install (2) L-brackets onto modesty panel (for panels
72" and wider, locate a third L-bracket at center of panel).
a) shows the locating dimensions for
installing the modesty panel flush with worksurface.
b) install brackets at this dimension when you are
suspending the modesty panel 1-1/2" from the
worksurface.
NOTE: Modesty panel needs to be mounted upside
down from normal orientation.
NOTE: The leg of the L-bracket with a hole nearest the
bend mounts to worksurface.
4.
Install modesty panel to worksurface in desired
location with (2) screws, each bracket.
2
#10 x 7/8" truss
head screws
(2 per bracket)
3a
13-1/2"
(343 mm) both sides
2-1/2"
(64 mm)
FLUSH MOUNTED MODESTY PANEL
1"
(25 mm)
SUSPENDED MODESTY PANEL
3b
For Meeting and Extended Bullet Worksurfaces
the modesty panel can "float", or be located in
various positions to meet the needs of the user.
Center
of holes
Page 10 of 10
P/N 939500227
Doc # 108322 Rev J
