SD1200 - Sectional Garage Door Opener
Page 11
Installation & Operating Instructions
V2.09/19
Coding Wireless Transmitters
The two (2) hand transmitters (remotes) and wireless wall switch supplied with your opener are
preprogrammed at the factory.
Additional transmitters can be coded as follows:
1)
Press and hold the “P” and “+” buttons until all lights turn on and LED 7 flashes
2)
Press the “+” button once
(all LED lights turn off except LED 7)
3)
Quickly press and release the required push button on your remote twice
(all LED lights turn on and
LED 7 will begin flashing)
4)
Press the “P” button once to save
(LED 3 will switch on indicating that the remote has been
successfully programmed)
If you fail to press the transmitter button whilst in coding mode within 7 seconds, the opener will
automatically return to standby mode.
Note: A maximum of 10 codes can be learned by the opener. If you want to program another transmitter
and the memory is already full the first code will be deleted.
Deleting transmitters:
Note: This procedure will clear all programmed remotes, wireless wall buttons and wireless keypads from
the opener.
1)
Press and hold the “P” and “+” buttons until all lights turn on and LED 7 flashes
2)
Press and hold the “
−
“ button until LED 7 turns off and begins flashing again
3)
Press the “P” button once to save
(LED 3 will switch on indicating that all codes have been deleted and
that the opener is now in normal operating mode)
Follow Procedure 1. above to code new transmitters.
IMPORTANT SAFETY NOTICE:
After programming opener always conduct a
safety check to test safety reversal system, see page 9.
Activate the opener only when door is in full view and free of obstruction. No one
should enter or leave the garage while the door is in motion.
