Steel City 40-660, Руководство пользователя

Страница: 11 / 20

Page 11
ASSEMBLY
BASE
1. With the carriage bolts and nuts,begin assembling one
end of the stand by attaching 1 short top shelf and 1
short tie bar to 2 legs.
NOTE : Do not tighten hex nuts until all fasteners are at-
tached.Then place the stand on a flat surface to square it
up and tighten all the nuts.
2. Assemble the opposite side of the stand as described
in step 1. Use the 2 long top shelves and 2 long tie
bars to join both assembled ends and complete the
stand as show in the fig 1.
3. Place the machine onto the stand and align the four
holes in the stands top shelf with the machine.
WARNING
!
Make certain that the machine is not connected
to the power source.
4 holes
ATTACH THE WORKTABLE TO THE
BASE
Align the 4 holes of the work table with the 4 thread holes
of the machine. Attach using the four phillips countersunk
screws.