Steca TK-RW1, Инструкция по установке и эксплуатации

Страница: 9 / 20

9
733.847 | 10.27
EN
5.2 Installation
In the following, the individual steps for setting up the remote display
are described. Please follow the sequence.
1. Connect the RS232 interface cable to the solar controller. Please also
see the instructions for the controller. Pay attention to the wire col-
ours.
Rx Tx
T
DANGER
Risk of fatal injury due to electric shock!
Prior to opening the controller casing, disconnect the controller from
the mains.
2. Connect the RS232 interface cable to the RS232-USB converter.
3. Plug the USB connector of the RS232-USB converter into the USB port
of the wireless LAN router for data transfer.
4. Plug the USB flash drive into the USB port of the wireless LAN router.
5. Attach the aerial to the wireless LAN router.
6. Connect the power supply of the wireless LAN router to the wireless
LAN router and connect to the mains.
NOTE
The wireless LAN router needs about 1 minute for system initialisation
after switching it on. The wireless LAN router is ready for use when
both the power LED and the "AIR" LED are permanently lit.
Exception: In the WPA or WPA2 mode, AIR will only light up after trying
to establish a connection between the picture frame and the wireless
LAN router.
7. Connect the solar thermal controller to the mains.
DANGER
Risk of fatal injury due to electric shock!
Make sure that the controller is closed.
8. Assemble the digital picture frame and put it into operation. Please
see the user manual Kodak EasyShare W820 and section 6 "Initial
commissioning W820”.


Terminal diagram of the
RS232 interface
or
an
ge
gr
ee
n
re
d