Steca StecaGrid 2010+ Master, Инструкция по установке и эксплуатации

Страница: 43 / 84

43
734.843 | 10.48
EN
1--5-1 Total energy The total energy that that has been produced
since the time of installation (individual read-
ings for master and slaves).
-1-1 Manual on/off By pressing the Enter button, master & slaves
can be switched on and off at this menu item.
--1 Inverter a Shows the status of the master. Options: acti-
vated, standby, sleep, off
-- Inverter b Shows the status of the 1st slave. Options:
activated, standby, sleep, off
--3 Inverter c Shows the status of the nd slave. Options:
activated, standby, sleep, off
-3-1
to
-3-n
Message 1
to
message n
Only applicable when there is a fault message.
The fault message is shown here.
3-1-1 Grid voltage, frequency, electric-
ity
Shows the current measured values for the grid
voltage, the electricity fed into the power grid
and the grid frequency.
3--1 PV voltage Shows the DC voltage of both inputs for both
the master as well as the slaves.
3-- PV current Shows the DC current of both inputs for both
the master as well as the slaves.
3--3 PV output Shows the DC output at both inputs for both
the master as well as the slaves.
3--4 Mains electricity Shows the electricity fed into the grid for both
the master as well as the slaves.
3--5 Primary bus voltage An internal voltage in the inverter. The value of
this voltage provides the technician with infor-
mation about the status of the inverter when
there is a fault.
3--6 Secondary bus voltage An internal voltage in the inverter. The value of
this voltage provides the technician with infor-
mation about the status of the inverter when
there is a fault.
3--7 Internal temperature Shows the current inner temperature of the in-
verter for both the master as well as the slaves.
4-1 System Shows the type, serial number and version
number of the relevant component.
4- Inverter a Shows the type, serial number and version
number of the relevant component.
4-3 Inverter b Shows the type, serial number and version
number of the relevant component.
4-4 Inverter c Shows the type, serial number and version
number of the relevant component.
4-5 Display Shows the type, serial number and version
number of the relevant component.
4-6 RFM Shows the type, serial number and version
number of the relevant component.
5-1-1 Time When the Enter button is pressed here, the
time starts to flash. It can be set by pressing
the arrow buttons. The setting is confirmed by
pressing the Enter button.
5-1--1 1 When the Enter button is pressed here, the time
is shown using the 1-hour clock, i.e. showing
AM/PM.
5-1-- 4 When the Enter button is pressed here, the time
is shown using the 4-hour clock.
5-1-3 Date When the Enter button is pressed here, the
date starts to flash. It can be set by pressing
the arrow buttons. The setting is confirmed by
pressing the Enter button.
5-1-4-1
to
5-1-4-3
yyyy-mm-dd
dd-mm-yyyy
mm-dd-yyyy
By selecting the relevant entry the correspond-
ing format is specified for displaying the date.
5--1-1 Always switched on By selecting this entry illumination of the display
is always switched on.
5--1- Always switched off By selecting this entry illumination of the display
is always switched off.
5--1-3 Energy-saving mode By selecting this entry illumination of the display
is automatically switched on as soon as the
navigation buttons are pressed. After the but-
tons are pressed the display remains illuminated
for a certain length of time before the illumina-
tion automatically switches itself off.