Steca coolcept StecaGrid 3000, Инструкция по установке и эксплуатации

Страница: 46 / 132

44
742.221 | 12.04
EN
3 General safety instructions
• This document is part of the product.
• Use the device only after reading and understanding this document.
• Always perform the measures described in this document in the sequence specified.
• Keep this document in a safe place for the entire service life of the device. Pass this document on
to subsequent owners and operators of the device.
• Improper operation can reduce the yields of the solar energy system.
• The device must not be connected to the DC or AC cables if it has a damaged casing.
• If one of the following components is damaged, immediately take the device out of operation
and disconnect it from the mains grid and solar modules:
– Device (not functioning, visible damage, smoke, etc.)
– Cables
– Solar modules
The system must not be switched on again until
– the device has been repaired by a dealer or the manufacturer.
– damaged cables or solar modules have been repaired by a technical specialist.
• Never cover the cooling fins.
• Do not open the casing! Risk of death! Invalidation of the guarantee!
• Factory labels and markings must never be altered, removed or rendered unreadable.
• Observe the manufacturer's manual when connecting an external device that is not described in
this document (e.g. external data logger). Incorrectly connected devices can damage the inverter.
Safety instructions on the device
10min
Montage
HV-Test
Endtest
Isoler les deux sources
avant toute
intervention
Attention
Présence de deux sources
de tension
- Réseau de distribution
- Panneaux photovoltaïques
5 2
1
3 4
 Manufacturer's production information

Dangerous voltages can remain present
on the components up to 10 minutes after
switching off the DC circuit breaker and the
line circuit breaker.

Warning. There are 2 voltage sources pre-
sent: power grid, solar modules.

Disconnect both voltage sources before
working on the device: The solar modules
via the DC circuit breaker and
the power grid via the line circuit breaker.

Read and follow the manual!
Fig. 2: Safety instructions on the device