This section covers installation of the following headrests on
UniLink
headrest hardware:
Comfort Plus Series
Adjustable
Comfort Plus Series
Combo Series
Tri-Comfort Plus
Series
To install a headrest to the
UniLink Headrest Hardware:
Place the 1” ball into the
designated socket in the rear
of the headrest.
Slip the split ring around the
1” ball, notch facing down.
Tighten screws with an M4 hex key, ensuring the screws are tightened
evenly and that the split ring is parallel with the mounting plate on the other
side of the 1” ball.
Insert the four M5 x 0.8 x 14
socket head screws (B) through
the ring and into the threaded
holes in the rear of the headrest.
Headrest Installation
9
Installation
CAUTION
Never use this product to maneuver a chair or anything to which it is
attached. This product is intended only for its stated use, and should never
be used as a support, lift, guide, handle, or an anything other than the
instrument of its original function.
