Q-Logic™ Setup
10.0
13
NOTICE
If using Q-Logic™ Specialty Control Input Module (SCIM), a mechanical
switch (any type) will need to connect to the on/off port of the joystick and the red
jumper of the joystick to the on/off jack on the chair to power the chair on/off and
ensure the SCIM as master control. Q-Logic programmer is required.
9-Pin Connector
Q-Logic™ Drive Control System
Q-Logic™ SCIM
NOTICE
For new chairs that have never been programmed, a power cycle
will need to be completed after the joystick has been calibrated
and before the joystick throw can be adjusted.
1.
Plug in the Q-Logic Handheld Programmer (Previous Page) to the Q-Logic ED (Enhanced
Display) or the standalone joystick if SCIM (Specialty Control Input Module shown below) is in
use.
2.
On the Q-Logic Programmer, navigate to
Program Adjustments
Enhanced Display (or SCIM)
Input Configuration.
3.
Toggle
Input Configuration
to
Proportional
with the
Plus & Minus
buttons.
4.
Turn off the system and unplug the Q-Logic Handheld Programmer. The chair should now be
programmed to recognize the
All-Round Lite Joystick
. Be sure to re-engage the motors
before operation.
Содержание IDM-ARLITE-9
Страница 1: ...All Round Lite Joystick Owner s Manual mo Vis All Round Lite Joystick...
Страница 42: ...Notes 18 0 35...
Страница 43: ...Notes 18 0 36...
