31
Q-Logic Installation
12.0
Setup for Q-Logic 3
1.
Power off the chair with the power button on the joystick or display.
2.
Ensure all the cords from the display are properly connected to the chair.
3.
Connect the i-Drive 9-pin connection into the port on the bottom of the Enhanced Display.
4.
With the chair powered off, open the i-Drive mobile app on a Bluetooth enabled device
and log in using the email and password provided to you. Power the chair on and connect
to the application.
5.
Plug the Q-Logic Programmer into the back of the Q-Logic display.
6.
On the Programmer, navigate to
Program Adjustments,
and with the
Right
button,
select.
7.
In the
Program Adjustments
option, navigate to
Enhanced Display
and select.
8.
In the
Enhanced Display
menu, navigate with the
Up & Down
buttons to
Input
Configuration.
Set this to
3 Direction Proportional Head Switch Operation.
9.
With the
Left
navigation button, go back into the
Enhanced Display
folder.
10. With the
Up & Down
buttons scroll down to the
Proportional Input
folder and with the
Right
button
select.
11.
In the
Proportional Input
folder, using the
Up & Down
buttons, select
Proportional
Calibration
, followed by
OK.
The programmer will read “
Roll around joystick in two full
circles”.
12.
On your i-Drive mobile app, go to
Config Mode,
then
Calibrate Chair.
13. Note the warning that will appear and then select,
Okay.
The app will now begin
calibration on its own. Once complete, the app will return to Config Mode on its own.
14. Select
OK
with the Q-Logic programmer and verify that calibration was successful.
15. Exit the programming, unplug the programmer, and cycle power.
16. Check your configuration on the Diagnostics tab of the app. If all is working correctly, your
i-Drive is ready to use.
17. Re-engage the motors.
DANGER
Disengage the motors before programming the chair.
Содержание IDHBT500
Страница 61: ...53 NOTES 17 0 ...
Страница 62: ...54 NOTES 17 0 ...
Страница 63: ...55 NOTES 17 0 ...
