10.6A
With pins facing up on the inside of the greenhouse, slide one end of
profile L05D into V-channel of profile L03P. Angle it slightly to fit the
other end into V-channel of profile L03Q.
10.6B
10.5B
10.4C
10.4D
Line up L05D channel with U-shaped
cutouts in sides of profiles L03P and L03Q.
Slide hex nut and bolts into U-shaped
notches and tighten securely.
L05D
L03P
IMPORTANT: Make sure the pins face UP on INSIDE
of the greenhouse when profile L05D is installed.
NOTE: The Auto Vent Opener will
be installed to the vent in step 10.10
L05D
L03Q
L05D
L03Q
10.4A
45 of 55
www.stcny.com
VIEWS FROM INSIDE.
10.5A
Slide two S13 hex bolts into channel
of profile L05D and four S13 hex bolts
into channel of profile L05G.
10.4B
Unpack contents of Auto Vent Opener. Screw
assembly knob partially into threaded end of
cylinder. Do NOT tighten.
Screw two S14 hex nuts onto bolts on ends of each
profile. Do not completely tighten.
S13
S14
L05G
L05D
L05G
L05D
L03O
L03N
L03P
L03Q
Fit piston rod connected to arm B into the end
of the cylinder. Turn cylinder so the holes
next to the adjusting knob are visible.
Continue pushing cylinder until the holes in the end of the cylinder
line up with the holes in arm A. Push arms apart if necessary. Secure
with a threaded stud on each side.
Turn the adjusting
screw clockwise
until the arms
are aproximately
15cm (6”) apart.
adjusting knob
cylinder
piston rod
cylinder
arm B
QTY
Threaded Stud
2
QTY
Adjusting Knob
1
QTY
1
Cylinder
QTY
1
Handle
arm A
NOTE: L05D has two hairpin clips used to secure
the handle of the vent to prevent it from moving
in high winds. See Step 10.9C for more details.
L05D
L03P
L03Q
#S13
#S14 4
6
QTY
1
1
Bolt / Nut
QTY
Profile
#L05G
#L05D
QTY
Profile
