Regulatory Information | 51
50 | Regulatory Information
The Starkey Charger has been tested to, and has passed, the following
emissions and immunity tests:
• IEC 60601-1-2 radiated and conducted emissions requirements for a Group 1
Class B device as stated in CISPR 11
• Harmonic distortion and voltage fluctuations affecting the power input source
as stated in Table 2 of IEC 60601-1-2
• RF radiated immunity at a field level of 10 V/m between 80 MHz and 27 GHz
as well as higher field levels from communications devices as stated in Table 9
of IEC 60601-1-2
• Immunity to power frequency magnetic fields at a field level of 30 A/m
• Immunity to ESD levels of +/- 8 kV conducted discharge and +/- 15 kV air
discharge
• Immunity to electrical fast transients on the power input at a level of +/- 2 kV at
a 100 Hz repetition rate
• Immunity to surges on the power input of +/- 1 kV line to line
• Immunity to conducted disturbances induced by RF fields on the power input
as stated in Table 6 of IEC 60601-1-2
• Immunity to voltage dips and interruptions on the power input as stated in
Table 6 of IEC 60601-1-2
WIRELESS NOTICES
FCC ID: EOA-24LIVIOBCHG
IC: 6903A-24LIVIOBCHG
FCC NOTICE
This hearing aid and Starkey Charger complies with part 15 of the FCC rules and
with ISED Canada license-exempt RSS standards Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation of the device
Note: The manufacturer is not responsible for any radio or TV interference caused
by unauthorized modifications to this equipment Such modifications could void
the user’s authority to operate the equipment
EU NOTICE
Hereby, Starkey Hearing Technologies declares that the rechargeable BTE is
in compliance with the essential requirements and other relevant provisions of
Directive 2014/53/EU A copy of the Declaration of Conformity can be obtained
from the address below or from docsstarkey hearingtechnologiescom
INSTRUCTIONS FOR DISPOSAL OF OLD ELECTRONICS
Starkey Hearing Technologies encourages, the EU requires, and your local
community laws may require, that your hearing aids and charger be
disposed of via your local electronics recycling/disposal process
The instructions below are provided for the benefit of disposal/recycling
personnel Please include this manual when disposing of your hearing aids and/
or charger
FOR DISPOSAL/RECYCLING PERSONNEL ONLY
These products contain Lithium-Ion Polymer batteries For instructions
on removing the battery from the hearing aids, please visit
docsstarkeyhearingtechnologiescom To remove the battery from the Starkey
Charger:
• Remove the four skid pads on the bottom of the charger base to
access fasteners
• Remove fasteners using a Phillips head screwdriver
• Disassemble the charger base from the bezel to expose the battery cell
• Cut the THREE battery wire leads ONE AT A TIME close to the battery cell
to avoid shorting
• Pry battery from base using a wide flat blade making sure not to puncture
the battery cell
Starkey Hearing Technologies
6700 Washington Ave South
Eden Prairie, MN 55344 USA
Starkey Laboratories (Germany) GmbH
Weg beim Jäger 218-222
22335 Hamburg
Germany
Class II Device
Waste from electronic equipment must be
handled according to local regulations
Consult Operations Manual
Keep dry
