SF-HC25C3 Height Controller
19
Raise the controller after power-on self-test, self-check project has panels
and the host software version number display, and host communications,
electrical circuit is normal, if the introspection through digital tube display not
normal or up and down limit indicator lamp lights up at the same time and
cannot perform any action.Self-checking by into working state and working state
is divided into two kinds: manual and automatic state.
Learning function:
set the arc pressure, set up to 60 v block work in self
learning mode.At this point, you just need to adjust positioning height.Do not use
this function only sets the set of arc pressure to the 60 v.
5.1
Manual operation
manual up signal (up) Effective or press the button
, the cutting torch
to rising
Manual drop signal (down) effective or press the button
, the cutting
torch to falling.
press the button
key long to perform the positioning action.
Rev ARC signal (ARC) : effectively, the positioning action first, and then
control and ARC plasma power.
5.2
Automatic operation
Reach to automatically adjustable requirement:
1. Start arc (ARC) signal effectively.
2. Automatic (AUTO) signal effectively.
3. Appropriate plasma cutting voltage ((set voltage-50) ~ (set v 60)).
文件使用
"pdfFactory Pro"
试用版本创建