– 9 –
(1) Make sure the printer is turned off.
(2) Affix the ferrite core onto the ethernet cable as shown in the
illustration below.
(3) Pass the fastener through the ferrite core.
(4) Loop the fastener around the cable and lock it. Use scissors to
cut off any excess.
4-2-4. Connecting Ethernet Cable
If a ferrite core is included, install the ferrite core onto the Ethernet cable according to the fol-
lowing procedure to prevent electrical noise.
If a ferrite core is not included, perform steps (1) and (5) only.
(5) Connect the interface cable to the connector on the rear panel of the printer.
Link disconnection detection feature
The Ethernet interface model is equipped with a link disconnection detection feature. If the
printer is turned on when an Ethernet cable is not connected to it, the POWER and ERROR
lamps are simultaneously turned on and off at 2-second intervals to indicate the disconnection.
Be sure to connect the Ethernet cable from a PC or hub to the printer, and then turn the printer
on.
Ferrite core
Ethernet cable
1 cm
(maximum)
Fastener
Ethernet Interface Board
IFBD-HE06
Ethernet Interface Board
IFBD-HE08
