14
TOTAL DELTS
INSTALLATION
NOTE:
take special care when unwrapping unit, do not use knifes to cut open packaging damage may occur.
STEPS:
1.
Take main body off the pallet and place it on the floor.
2.
Attach the seat pad frame to the main body. (Note: cables are attached to this assembly, take special
care to not pinch, twist or damage cables. Make sure cables travel straight).
Use (4) M12 washers and (4) M12 x 30 button head screws to a t t a c h seat frame to the main body,
tighten fasteners to (84 NM / 62 ft-lb) torque.
3.
Take the knee pad assembly; remove M6 Phillips head screw and washer. Slide knee pad assembly into
main body; re-install M6 Phillips screw and washer.
4.
Attach accessories to the unit.
5.
Place urethane boots under feet.
