D-F0382 NP-266/366 Product specifications Ver.1.10
23
5.3 Line mode command details
1) Horizontal tab
: << HT >>
Code
: [09] h
Shift the print position to the next horizontal tab position
* Horizontal tab position is set by [horizontal tab set] command.
* The default status of horizontal tab position is set at every 8th character (9th digit,
17th digit, 25th digit and 33rd digit) in font A.
※
41st digit for NP-366
* If the next tab position is not set, this command is ignored.
2) Line feed
: << LF >>
Code
: [0A] h
Prints data stored in the print line buffer and executes line feed according to data
of feed pitch.
3) Page feed : << FF >>
This command is effective only in Windows mode.
Code : [0C] h
* Prints data in the print line buffer and executes page feed to the head of next page
according to the page length in the setting.
* Default setting for the page length is [42] h ( 66 lines) .
4) Carriage return: << CR >>
Code
: [0D] h
This command is ignored.
5) Software reset : << DLE CAN >>
Code : [10] h + [18] h
Description :Firmware is treated in the same manner as power is set on to start again.
* The command is stored in the internal receive input buffer and activated sequentially.
* After cutter action is completed, but during operation process, it returns to software
operation.
* If there is any data, not yet transferred, in the transfer buffer, it goes to software reset action
after all data are transferred.
6) Setting right space of a character: << ESC SP n >>
Code
: [1B] h + [20] h + n
* [00
≤
n
≤
20] h
Sets the right space of a character by unit of dot (1/203 of an inch). In the case of
double width mode, the space will be doubled. The default value of “n” is [00] h.
