Stanley SRP 2240, Руководство пользователя

Страница: 23 / 28

SRP 2240 / 3860 User Manual ◄ 23
MAINTENANCE
V-Belt: Tension / Condition - SRP 2240 V-Belt: Tension / Condition - SRP 3860
• Remove V-belt guard.
• Check V-belt for tension and condition.
• Tension if necessary:
SRP SRP 3860
• Remove V-belt guard.
• Check V-belt for tension and condition.
• Tension if necessary:
• Unscrew the nuts (1) of the rubber stops on the outside.
• Push the upper tray (2) upwards on both sides.
It is important to ensure that the frame is also
actually pushed on the rubber stop contact
surfaces and not just the rubber elements are
stretched and then spring back again. If neces-
sary apply light blows with a hammer to knock
the rubber stops downwards.
• Both buffers should be equally pre-tensioned.
• Tighten nuts (1).
• Crank the drive manually and re-check tension and
correct if necessary.
• Replace V-belt guard.
Do not start the engine without V-belt
guard. Danger of injuries.
Do not start the engine without V-belt
guard. Danger of injuries.
Danger
Danger
• Check the tension of the V-belt after 25 op. hrs. again.
Adjust the tension if necessary.
• Check the tension of the V-belt after 25 op. hrs. again.
Adjust the tension if necessary.
• Loosen set screws (1), do not unscrew.
• Insert auxiliary tools (ø 6 mm) into bores (2) and (3).
• Tension vee-belt by turning clutch halves (2) and (3) in
opposite directions
• Tension clutch halves (2) and (3). X= 10 mm.
• Crank the drive manually and re-check tension and
correct if necessary.
• Replace V-belt guard.
Important