6
SAFETY PRECAUTIONS
Read the Manual
Wear Eye
Protection
Wear Ear
Protection
Wear Dust Mask
To avoid serious injury or death
47351
Tool operators and maintenance personnel must always comply with the safety
precautions given in this manual and on the stickers and tags attached to the tool
and hose.
These safety precautions are given for your safety. Review them carefully before
operating the tool and before performing general maintenance or repairs.
Supervising personnel should develop additional precautions relating to the specifi c
work area and local safety regulations. If so, place the added precautions in the
space provided on page 5.
The model HD08 Hydraulic Hammer Drill will provide safe and dependable service if
operated in accordance with the instructions given in this manual. Read and under-
stand this manual and any stickers and tags attached to the tool and hose before
operation. Failure to do so could result in personal injury or equipment damage.
• The operator must start in a work area without bystanders. Flying debris can cause serious injury.
• Do not operate the tool unless thoroughly trained or under the supervision of an instructor. Establish a training program
for all operators to ensure safe operation.
• Always wear safety equipment such as goggles, ear and head protection, and safety shoes at all times when operating
the tool. Use gloves and aprons when necessary.
• The operator must be familiar with all prohibited work areas such as excessive slopes and dangerous terrain conditions.
• Do not inspect, clean or replace any part(s) if the hydraulic power source is connected. Do not inspect or clean the tool
while the hydraulic power source is connected. Accidental engagement of the tool can cause serious injury.
• Always connect hoses to the tool hose couplers before energizing the hydraulic power source. Be sure all hose connec-
tions are tight and are in good condition.
• Do not operate the tool at oil temperatures above 140°F/60°C. Operation at higher temperatures can cause higher than
normal temperatures at the tool which can result in operator discomfort.
• Do not operate a damaged, improperly adjusted, or incompletely assembled hammer drill.
• Never wear loose clothing that can get entangled in the working parts of the tool.
• Keep all parts of your body away from the drill and maintain proper footing and balance at all times.
• When working near electrical conductors, always assume that all conductors are energized and that insulation, clothing
and hoses can conduct electricity. Stay a safe distance away from electrical conductors.
• If the hydraulic power supply has been interrupted, place the hammer drill in the OFF position before restarting the hy-
draulic power supply.
• To avoid personal injury or equipment damage, all tool repair, maintenance and service must only be performed by au-
thorized and properly trained personnel.
Содержание HD08
Страница 2: ...2...
