Installation
The installation must meet the requirements of the country of installation’s National Wiring
Regulations and EN60950-1. It must be only carried out by competent, qualified and
experienced personnel. Failure to do so can result in injury or death by electric shock.
Note:
See the section on Boxed Easikey 250 for further instructions relating to the
installation of a Boxed Easikey 250 or Boxed Easikey 250 with Cutout.
Quick Start
If you have installed an Easikey 250 system before then you can follow this simple step-by-
step checklist to get the system up and running. If you are new to Easikey 250 then all the
steps below are described in detail in the following pages.
Step
9
1. Install the Easikey 250 controller and power supply in an enclosure or other
secure area.
2. Install the readers and reader cables, including any request to exit switches.
3. Install the electric locks and their cables.
4. Initialise the Easikey 250, set the number of Editor Keys and add one or more
keys.
5. Set the lock release time for each lock.
6. Check the operation of each reader and lock.
7. Add any remaining keys to the controller — use the Worksheet to record details of
keyholders.
13
