ASSEMBLY INSTRUCTIONS
8
STEP 5:
Refer to the inset drawing. Lay the
UPRIGHT(6)
on the floor close to the front of the
MAIN
FRAME(1).
Turn the
TENSION KNOB(22)
on the
UPRIGHT(6)
counterclockwise as far as it can go
,
so the
cable end extends out of the metal fitting as far as possible. Connect the
CABLE END
of the
TENSION
KNOB(22)
into the
SPRING HOOK
on the end of the
TENSION CABLE(21).
Pull the
CABLE
on the
TENSION KNOB(22)
firmly and insert the cable through the slot in the bracket. Then insert the
METAL
FITTING
on the end of the
CABLE
of the
TENSION KNOB(22)
into the hole at the end of the slot in the
BRACKET.
Adjust the
TENSION KNOB(22)
and verify that the
SPRING HOOK
moves when the
TENSION
KNOB(22)
is adjusted.
Bracket
Cable End
Spring Hook
Metal Fitting
Insert the
UPRIGHT(6)
into the
MAIN FRAME(1)
and secure with
BUTTON HEAD BOLTS
(M8x1.25x57mm)(49), ARC WASHERS(M8)(65),
and
NYLOCK NUTS(M8x1.25)(60).
STEP 6:
There is a strap attached inside of the
UPRIGHT(6).
This strap is to assist in pulling the
SENSOR
WIRE(24)
through the
UPRIGHT(6).
Tie the strap to the plug end of the
SENSOR WIRE(24).
Pull the strap from the top of the
UPRIGHT(6)
to
pull the
SENSOR WIRE(24)
through the
UPRIGHT(6)
as shown in the above illustration. The
SENSOR
WIRE(24)
must extend out the top of the
UPRIGHT(6).
Make sure the
NYLOCK NUTS(M8x1.25)(60)
fit into the hex holes on the top of the
MAIN
FRAME(1)
before tightening the
BUTTON HEAD BOLTS(M8x1.25x57mm)(49).
Be careful not to damage the
SENSOR WIRE(24)
when assembling the
UPRIGHT(6).
1.
2.
STEP 7
NOTE:
Strap
Strap
Содержание INSTRIDE 55-1615
Страница 16: ...PRODUCT PARTS DRAWING BACK FRONT 16 Strap Strap...
Страница 20: ...20 NOTES...
Страница 21: ...21 NOTES...