15
16
Tilting the table
The bandsaw table tilts up 45°
to the right or up to 10° to the
left. TO tilt the table(Fig.)
1. Loosen knob under the
table(Fig. A)&(Fig.,C).
2. Tilt table the desired angle
of degree, gauge under the
table.
3. Re-tighten knob.
C
15
ADJUSTMENT
Table assembly
1. Place table bracket on the
bandsaw so that the two bracket
pins can go into the holes on the
support.
2. Secure table bracket to
bandsaw body using the two hex
head bolt and flat washers(Fig.1)
3. Set table on bracket, insert
screw into bracket and secure with
knob
Adjusting to 90° table stop
1. Disconnect the machine from the power source.
2. Loosen the lock knobs (A) as
illustrated in (Fig.) tilt the
table towards the left until it
rests against the table stop
bolt.(Fig.,B)
3. Use a square, place on the
table against the blade. This
will allow you to verify the 90
degree to the table.
4.
Turn table stop bolt to get the
90-degree angle; tighten
thelock knobs once completed.
A
B
Содержание CWI-B1512
