13
14
POWER SUPPLY REQUIREMENT
Insufficient voltage from factory power source may affect the power output of the motor and
the function of the controller.
It is important to connect this machine to the correct voltage in the factory power source.
Use only an independent power source.
3.7 CONNECT POWER SOURCE WIRES
1. Before connecting the power wires make sure the voltage between the machine and your
factory power source is the same.
2. Take out the electrical cover at the electrical control box outside.
3. Connect the power wires to the plug.
4. The machine must be properly grounded to prevent possible injury from electrical shock.
5. Connect the power wires from machine bed to the electrical control box according
connecter type.
6. Qualified electrical personnel should perform all electrical connections.
Grounding should be based on the local regulations.
13
the machine to open or remove doors/covers as required by the maintenance and service
described in this manual.
Electrical Installation
Place this machine near an existing power source. Make sure all power cords are protected
from traffic, material handling, moisture, chemicals, or other hazards. Make sure to leave
assess to a means of disconnection the power source or engaging a lockout/tagout device.
Lighting
Lighting around the machine must be adequate enough that operations can be performed
safely. Shadows, glare, or strobe effects that may distract or impede the operator must be
eliminated.
TRANSPORTATION
Carefully check over the machine whether it is damaged during transportation.
While moving the machine, be sure to note its weight distribution as well as its balance.
If the machine is damaged while being moved, please contact the manufacturer immediately.
The lifting of the machine is as easy as follows:
The machine can be lifted by a forklift.
Their forks should insert through the machine bottom.
Attention should be paid to the balance of the machine while lifting.
Содержание CWI-B1512
