EN
ALARM
DESCRIPTION
Alarm
PF
Alarm description:
•
Shutting off the power supply or oven switched off unproperly. It is activated when there is a power
supply shut off or when the oven is switched off unproperly. To switch it off properly, the oven must
be switched off when “PRESSTO ACTIVATE” is displayed on the screen.
Solutions:
•
Press the alarm so that it disappears from the screen.
•
Check the device electrical connection.
•
Check the unit power supply.
•
Check that the oven is being switched off when “PRESS TO ACTIVATE”is displayed on the screen.
Main consequences:
•
If the power supply shuts off during a cooking/cooking cycle, when the power supply is restored the
cycle will start from the beginning of the cycle if the power supply shut off is lower than 60 minutes,
otherwise, the cycle will be interrupted.
Alarm
COM.BASE
Alarm description:
•
COM BASE (without communication between the control module and the screen).
Solutions:
•
Check the wiring connecting the screen to the power board. To do so, check that the white wire (pin
35) and yellow wire (pin 34) are appropriately connected both to the power board and to the
screen.
Main consequences:
•
If the alarm is activated when the device is ON, no cooking cycle can be started.
•
If the alarm is activated during a cooking cycle, this cycle will stop.
Thermal protec-
tion Alarm
Alarm description:
•
Motor thermal protection.
Solutions:
•
Switch the oven off and switch it on again after 10 minutes.
•
Check visually if there is a motor in poor conditions. If so, replace it.
•
If possible, check that there is continuity in the internal klixon of motors to detect which motor is in
poor conditions. When detected, replace it.
Main consequences:
•
If the alarm is activated when the device is ON, no cooking cycle can be started.
•
If the alarm is activated during a cooking cycle, this cycle will stop.
Alarm
HT
Alarm description:
•
Overheating of the oven power board.
Solutions:
•
Check that the plate cooling fan works appropriately.
•
Check that the oven is installed according to the safety distances shown in this manual and that there
is no element obstructing the outlet of hot air through the ventilation holes.
•
If the alarm does not stop, contact the Technical Support Service.
Alarm description:
•
Open-door alarm.
Solutions:
•
Check that the door is completely closed.
•
Check that the door sensor is not damaged. If so, replace it.
•
Move the door sensor closer to door.
•
If the alarm does not stop, contact the Technical Support Service.
Main consequences:
•
If this alarm is activated during a cooking cycle, this cycle will stop until the door is closed.
-42-
