Stahl EC-940-DUA Series, Инструкция по эксплуатации

Страница: 73 / 606

Instruc
tion manual - English - EN
71 MNTCMPXT_1824_EN
SOLUTION Wait until the end of the pre-
heating procedure. If the ambient
temperature is too low the unit
will remain disabled and the
following message will be shown:
Address : 1
DE-ICE PROCEDURE
------------------------
SYSTEM BLOCKED
TEMPERATURE TOO LOW
------------------------
PROBLEM Error E1-AUTOPAN WITHOUT
LIMITS.
CAUSE The two presets used as limits
have not been programmed.
SOLUTION Program the two presets and
then update the Autopan
configuration menu (10.2
Saving a Preset, page 63 e 9.6.4.7
Autopan Menu, page 48).
PROBLEM Error E2-WIPER BLOCKED.
CAUSE The wiper is either jammed or
broken.
SOLUTION Check that the wiper is free to
move.
PROBLEM Error E3-PATROL WITHOUT
PRESET or error E4-PATROL, 1
PRESET ONLY.
CAUSE The presets have not been
programmed.
SOLUTION Program two or more presets
and then update the Patrol
configuration menu (10.2 Saving
a Preset, page 63 e 9.6.4.6 Patrol
Menu, page 48).
PROBLEM Error E5-IR TEMP. TOO HIGH or
error E6-IR FAULT.
CAUSE The infrared illuminator is not
working properly.
SOLUTION Contact the authorized service
centre.
PROBLEM Error E7-PRST. NOT
CONFIGURED.
CAUSE Recalling of a non programmed
preset.
SOLUTION Save the preset using the relative
control (10.2 Saving a Preset,
page 63).
PROBLEM Error E8-TOUR NOT
CONFIGURED.
CAUSE Recalling of a non configured
Tour.
SOLUTION Save the Tour using the relative
control (10.6 Recalling a pattern
(Tour), page 64).
PROBLEM Error E9-TEMP. TOO LOW.
CAUSE The ambient temperature is too
low.
SOLUTION The movements of the P&T unit
is blocked to prevent mechanical
damage.