137189 / 8146619300
2016-11-10·BA00·III·en·06
Product Selection, Project Engineering and Modification
9
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Terminal Boxes
Series 8146/1, Series 8146/2
5.1
Additional Through Holes in Flange Plates
5.1.1 Creation of Additional Drilled Holes and Through Holes by R. STAHL
Forward the following information to R. STAHL:
- Type
- Data sheet
- Quantity, manufacturers and approvals of the components that are to be installed.
R. STAHL
• will check whether the components, drilled hole diameters, quantity and position
correspond with the approval
• will create the drilled holes and through holes
• will mount the components
• will update the order documentation
• will carry out a routine test
• will, if necessary, fit a new type plate if the technical data has changed,
e.g. due to the components that are to be additionally installed.
5.1.2 Ascertaining the usable Area for Cable Entries in Flange Plates
All dimensions in mm [inches]
18495E00
Collision frame and earth connection of flange plate
Select a space/area for the cable entry on the flange plate anywhere inside the collision
frame (see thin line in figure). Ensure that screw connections made later do not go beyond
this collision frame.
Observe the following conditions when doing so:
Leave enough distance to the circumferential seal (min. 3 mm)
(see detail in figure).
3
12
[0, ]
3
12
[0, ]
