137189 / 8146619300
2016-11-10·BA00·III·en·06
Product Selection, Project Engineering and Modification
11
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Terminal Boxes
Series 8146/1, Series 8146/2
5.2.2 Creation of Additional Drilled Holes and Through Holes by the Customer
Modify the device carefully and only in accordance with the safety notes
(see "Safety" section).
Calculate the usable area for built-in components, see sections 5.1.2 and 5.2.2.
Create additional through holes by lasing or punching (drilling, hole cutting).
When doing so, maintain a distance of min. 10 mm to the rim of the enclosure
(see figure).
All dimensions in mm [inches]
18478E00
When punching and cutting, make sure that the outer surfaces of the enclosure remain flat
and undamaged (without cracks).
When determining the through holes, observe the mounting distances.
Adjust the hole diameters to the dimensions of the built-in parts or their seals.
ONLY use built-in components with flat seal (gasket).
Observe section 5.3 when subsequently equipping components!
5.2.3 Creation of Additional Drilled Holes and Through Holes in the Enclosure with Flange Plate by
R. STAHL
Give the following information to R. STAHL:
- Enclosure side
- Type
- Data sheet
- Quantity, manufacturers and approvals of the components that are to be installed.
R. STAHL
• will check whether the components, drilled hole diameters, quantity and position
correspond with the approval
• will create the drilled holes and through holes
• will mount the components
• will update the order documentation
• will carry out a routine test
• will, if necessary, fit a new type plate if the technical data has changed,
e.g. due to the components that are to be additionally installed.
10 [0,39]
10 [0,39]
10 [0,39]
10 [0,39]
