5
5.
Turn the box back onto the bottom and then grab the box
and pull it up and off of the bike, exposing the bike and setting
on the floor.
6.
Remove all of the packaging from the bike
. Note: To
prevent cut marks on the bike, make sure to use side cutters
to cut strings and/or tie straps versus knives. Also make sure
when unpacking the handlebars to not lose the wedge pin.
7.
Install the handlebars by inserting the handlebars through
the handlebar stem and then lock the forward and aft
adjustment by tightening the adjustment knob. Install the end
cap on the front of the handlebars with the four (4) screws
provided.
Note: Do not install the end cap if you are going
to be adding Aerobars in lieu of the end cap. If installing the
end cap, do not overtighten the cap.
8.
Tighten the up and down handlebar movement by engaging
the FitLoc on the front of the handlebar stem.
9.
Lock the seat forward and aft adjustment by tightening the
adjustment knob.
10.
Tighten the up and down adjustment by engaging the FitLoc
on the frame directly below the seat.
