Stageline SP218UXL, Описание

Страница: 34 / 44

SP218UXL-19“
34
Push the mode-button and keep it down, then give the button [c] a
short push. Now letting off mode-button again. The display changes
to the set-up menu to the first parameter. Pressing mode-button
again shows the next parameter.
!
Without a further keystroke, within 5 seconds, the set-up is left
again.
The new address is saved by pressing the mode-button for one
second. The display becomes dark and returns to the active Mode
after letting off mode-button.
5.4.1 Merger start address
M c b a
Basicly both DMX512 lines, from IN A and IN B, are brought
together 1:1 by the merger. The start address defines the channel
of the first universe from where the second universe starts merging.
The setup of the address is made by typing the corresponding
button separately for every segment. The numbers run through from
0 -9. Addresses bigger than 512 aren't taken on.
! Provided that both DMX512 lines should brought together 1:1, the
address also can be put on 000. This switches the address
calculation off and leads to a shorter delay.
5.4.2 Locking address to IN B
M c b a
This address is shown to modes
n & u only (4.1.3). The locking
address is valid for a channel of input A and locks Input B as of a
value >60%. The decimal point indicates the "A." for locking
address. (attitude as described in chapter 5.4.1)
c-b-a
c-b-a