STACKER 500KS USER GUIDE 16
IMPORTANT: The supplied setup block is only used during bed leveling! Once the bed is
level, you do NOT use the block when homing the Z bed prior to printing.
In the next step you will remove the block from under the zprobe and move the block to different
locations on the bed. The setup block is used as a gauge to set the bed to the same plane as the
nozzles. You are not “leveling” the bed with a level. You are setting the bed to the same plane as
the x/y gantry.
Step 3. Move the X/Y gantry to the back of your print bed and position the heads, as shown
below.
The prefered method for moving the gantry is via Manual Control. Press the button until the
gantry has moved to the back.
Position heads one and two on the left side of the gantry, and if you have a 4head model push
heads three and four to the far right side of the gantry, as shown below.
You use head 2 for
leveling the bed.