LAR 350
10
en
1x
(17)
(20)
(3)
1x
1x
This mode is always set directly after the unit is switched
on (button 3). Other modes can be selected by pressing
button (3) or button (4) or using the remote control unit.
In ‘Automatic’ mode the laser unit levels itself automatically.
Place the laser unit in the appropriate working position
(vertical or horizontal). To switch on, press button (3) once.
Now the LAR 350 is in ‘Automatic mode with tilt function’.
The automatic levelling process begins. Once levelling is
completed, the beam stays on constantly and begins to
rotate. Fine adjustments can still be made within the first
30 seconds. These 30 seconds are indicated by a slow
flashing of the white LED (5).
When the tilt function is active, the white LED (5) is lit
steadily. If any event occurs that could result in the laser
unit being deflected from its exact alignment and setting,
the beam ceases to rotate and the blue (8) and green (9)
LEDs flash. If this occurs, check the laser unit and set it up
once again if necessary.
If the tilt function is triggered, this must be acknowledged
by pressing button (3) or, on the remote control unit, by
pressing buttons (17) + (20). Only after this can you proceed
further.
If you are working in conditions where interference is present
(e.g. on vibrating surfaces), it is recommended that you
select ‘Automatic operation with relevelling’.
8.1 Automatic Operation with Tilt Function
(3)
1x
(4)
