LAR 350
9
en
The tilt function warns if any interference to the laser has
occurred that may cause misalignment. This ensures that
such interference does not go unnoticed.
When the tilt function is active, the white LED (5) is lit
steadily. If any event occurs that could result in the laser
unit being deflected from its exact alignment and setting,
the beam ceases to rotate and the blue (8) and green (9)
LEDs flash. If this occurs, check the laser unit and set it up
once again if necessary.
If the tilt function is triggered, this must be acknowledged
by pressing button (3) or, on the remote control unit, by
pressing buttons (17) + (20). Only after this can you proceed
further.
The tilt function can be switched on or off in any mode
(touch button (3) briefly). When the laser unit is switched
on (button 3), tilt mode is always initially activated.
7. Tilt function
Deactivated tilt function
If the tilt function is deactivated (white LED flashing),
no warning is given of any change in the setting/alignment
in the event of interference. In automatic operation,
however, the unit re-levels itself automatically.
1x
(17)
(20)
(3)
1x
1x
