background image

Safety

2

READ AND FOLLOW 

SAFETY INSTRUCTIONS!

This is the safety alert symbol. 

When you see this

symbol on your pump or in this manual, look for

one of the following signal words and be alert to the
potential for personal injury:

warns about hazards that 

will 

cause serious

personal injury, death or major property damage if
ignored.

warns about hazards that 

can

cause serious

personal injury, death or major property damage if
ignored.

warns about hazards that 

will

or 

can

cause

minor personal injury or property damage if ignored.

The label 

NOTICE

indicates special instructions which

are important but not related to hazards.

Carefully read and follow all safety instructions in this
manual and on pump.

Keep safety labels in good condition. 
Replace missing or damaged safety labels.

1. Read this manual carefully. Failure to follow these

Instructions could cause serious bodily injury and/or
property damage.

2. Check your local codes before installing. You must

comply with their rules. 

3. Vent sewage or septic tank according to local codes.

4. Do not install pump in any location classified as 

hazardous by National Electrical Code, ANSI/NFPA
70-1990.

Hazardous voltage, Can shock, burn or

cause death. 

During operation, the pump is in water. To

avoid fatal shocks, proceed as follows if pump needs ser-
vicing:

Risk of electrical shock. Can burn or kill.

Do not lift pump by power cord. See “Cord Lift
Warning” on Page 5.

5A. Disconnect power to outlet box before unplugging

pump.

5B. Take extreme care when changing fuses. Do not

stand in water or put your finger in fuse socket.

5C. Do not modify cord and plug. When using cord and

plug, plug into a grounded outlet only. When wiring
to a system control, connect pump ground lead to
system ground.

6. Do not run pump dry. Dry running can overheat

pump, (causing burns to anyone handling it) and will
void warranty. 

7. Pump normally runs hot. To avoid burns when ser-

vicing pump, allow it to cool for 20 minutes after
shut-down before handling it.

8. In normal service, motor should not need oiling.

Motor has been filled at the factory with a special
oil.

LIMITED WARRANTY

Sta-Rite Industries warrants to the original consumer of the products listed below, that they will be free from defects in material and workman-
ship for the Warranty Period from the date of original installation or manufacture as noted.

Product

Warranty Period

Water Systems Products – jet pumps,

whichever occurs first:

small centrifugal pumps, submersible pumps

1 year from date of original installation, or

and related accessories

2 years from date of manufacture

Hydro-Flow Filters

1 year from date of purchase

Signature 2000

®

Fibrewound Tanks

5 years from date of original installation

Pro-Source

TM

Steel Pressure Tanks

5 years from date of original installation

Pro-Source

TM

Epoxy-Lined Tanks

3 years from date of original installation

Sump/Sewage/Effluent Products

1 year from date of original installation, or
2 years from date of manufacture

Our warranty will not apply to any product that has been subject to negligence, misapplication, improper installation or maintenance. In the
event a three phase submersible motor is operated with single phase power through a phase converter, or if three-leg ambient compensated,
extra-quick trip overload relays of recommended size are not used, our warranty is void.
Buyer’s only remedy and Sta-Rite Industries’ only duty is to repair or replace defective products (at Sta-Rite Industries’ choice). Buyer agrees to
pay all labor and shipping charges associated with this warranty and to request warranty service through the installing dealer as soon as a prob-
lem is discovered. If warranty service is requested more than 30 days after the Warranty Period has ended, it will not be honored.
STA-RITE INDUSTRIES SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL, INCIDENTAL, OR CONTINGENT DAMAGES WHATSOEVER.
THE FOREGOING WARRANTIES ARE EXCLUSIVE AND IN LIEU OF ALL OTHER EXPRESS WARRANTIES. IMPLIED WARRANTIES, INCLUD-
ING BUT NOT LIMITED TO THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL
NOT EXTEND BEYOND THE WARRANTY PERIOD PROVIDED HEREIN.
Certain states do not permit the exclusion or limitation of incidental or consequential damages or the placing of limitations on the duration of
an implied warranty, therefore, the limitations or exclusions herein may not apply. This warranty sets forth specific legal rights and obligations,
however, additional rights may exist, which may vary from state to state.
Supersedes all previous publications.

Sta-Rite Industries, 293 Wright St., Delavan, WI  53115

Содержание S44018T













Отзывы: