User Manual
Embedded EtherNet/IP Module
GS11-EI
40
This setting cannot be changed after confirmation. If you need to change the data type, you can create a new
module.
IP Address: Set the IP address of the EtherNet IP Slave module need to be connected, it is also the GS11-EI's
IP address.
Connection Parameters: Set the connection parameters used in the communication. For the connection
parameters supported by the GS11-EI, see the previous chapter.
Note: The size of "Size" set in the above figure (the number of bytes set) should be consistent with the
number of input and output bytes corresponding to the Instance described in the previous chapter.
Click "OK" to set the polling interval of the master station in the pop out interface. The default is 10ms, as
shown below:
After setting the master polling interval, click "OK" to save. Double-click "Controller Tags". In the pop out
window, click "GS11EI: O", as shown below:
