User Manual
Embedded EtherNet/IP Module
GS11-EI
31
Work mode: The first combo box in Parameters Configuration session is to set work mode, the current
version of the GS11-EI only supports user-defind protocol operating mode.
Setting the IP address via host interface (UART): when you choose it, “IP configuration mode”, “IP
address”, “Subnet mask”, “Gateway address” can be changed. It is choose to set the IP address through
the serial port. See the Advanced Parameters in section 6.4.
Input-data bytes, Output-data bytes: The value must be same with the max input and output data bytes of
EtherNet/IP set in the Advanced Parameters.
7.3 Establish/Disconnect Connection
Data in the Parameters Configuration section has default value, and you can input the value you need and
click “Run”. There will pop up a dialog box to configure serial port:
Data Receiving section: To
display the data received.
Data Transmitting section: To
display the data need to be sent.
Parameters Configuration section: To
configure the parameters.
