INSTRUCTION SHEET
PRR-1600 PULSE RADIO RECEIVER
(con't)
RADIO RF INPUT -
The PRNR-1600's Receiver/Antenna Unit contains a low-power 900MHz radio transceiver
with an integral antenna mounted inside the unit. Observe the following application guidelines: 1.) Mount the
transceiver as directed on the reverse side of this sheet; 2.) Locate the PRNR-1600 Receiver/Antenna unit so it
is LINE-OF-SIGHT with the transmitter of the system; 3.) Ensure that all metal objects, trees and other
obstructions, which may affect the distance the radio system will effectively work, are not within the line-of-sight
between the transmitter and receiver.
Revision: 4/10/22
PRR-16
Receiver
Base Unit
(Not to Scale)
8 conductor (4-twisted pair)
#24AWG shielded Control
Cable -100' max.
POWER INPUT - The PRNR-1600 receives its power supply from the PRR-16 Receiver Base unit.
NOTICE TO USER
- This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
* Consult the dealer or an experienced radio/TV technician for help.
In order to maintain compliance with FCC regulations, shielded cables must be used with this equipment.
Operation with non-approved equipment or unshielded cables is likely to result in interference to radio and TV
reception. The user is cautioned that changes and modifications made to the equipment without the approval of
manufacturer could void the user's authority to operate this equipment.
1
2
3
4
5
6
7
8
9
PULSE OUTPUTS -
See the PRR-16 Base Unit Instruction Sheet for detailed information on connecting the KYZ
Outputs to the receiving device. The receiving (destination) device may be the input to an energy management
system, recorder, SCADA system, RTU, or other device configured to receive pulses.
12
PRNR-1600
Receiver/
Antenna Unit
Dip Switch DS1
2 3 4 5 6 7 8
1
4
CHAN
2
1
RSSI
R/L