DIGIVEX Little Drive Servoamplifier
42
PVD 3530 GB 01/2005
In the case of long lengths
In the case of long cable lengths, there is a special function in the DLD variable speed drive for
versions of software above or equal to AP516V07, running with PME version 4.04 or above. This
function is used to adapt the variable speed drive switching mode according to the length of the
cable. Parameters can be set with PME in “Servo-control settings” under the hardware tab.
There are three possibilities:
-
Default values (8kHz) + PWM mode 1
-
4kHz + PWM mode 1
-
4kHz + PWM mode 2
The parameters to be applied are as follows:
Cable length
(shielded and non-shielded)
L< 50m
50m < L < 80m
80m < L < 120m
Settings Default
value+DSF01
4kHz
PWM mode1+DSF01
4kHz
PWM mode 2+DSF01
Only modify the parameters in these specific cases. Follow any modification by shutting
down and restarting the variable speed drive.
Connection by connector
The power connection on the motor by connector is available as an option. The mating part of
the connector (plug) can be supplied on request.
This manual was downloaded on www.sdsdrives.com
+44 (0)117 938 1800 - [email protected]
