SQlab
|
SPOR
TS ER
GONOMICS
|
HANDLEB
AR GRIPS
|
EDITION US 2
02
0-01
|
P
ag
e
11
The SQlab 702, 710, 710 short, 7OX, 711 R. 711 and 711 ltd. RUH grips should be mounted on a clean, grease-free handlebar.
Push the grips completely onto the handlebars until they stop. It is essential that you observe the correct side assignment (left/ right),
make sure to set the grip angle to the neutral position already now.
The grip SQlab 711 has a much shorter hard plastic sleeve for clamping. Therefore it is more difficult to slide the grips onto the handlebar.
The handle SQlab 711R is a conventional handle made of a silicone rubber mixture without clamping, therefore it is more difficult to slide
them onto the handlebar too.
For an easier assembly of the SQlab 711/711R grips, they can be moistened with brake cleaner on the inside. When using brake cleaner,
make sure to keep the grip away from the body when spraying. Brake cleaner usually sprays with extremely high pressure. Wear protec-
tive rubber gloves. Best to use outdoors.
The grips SQlab STUBY and STUBY short should be mounted on a clean, grease-free handlebar. Make sure that the grips are completely
pushed onto the handlebars and are flush with them. The bar ends must always face forward in the riding direction. Now tighten the grips
with the specified torque and push the handlebar plug into the outer end of the handlebar.
Warning
When using cleaning fluids or brake cleaners, it is essential to observe the corresponding safety instructions for their use and to
use appropriate safety equipment (chemical protection goggles and latex gloves). Avoid contact with skin and eyes. Ensure ade-
quate ventilation. Avoid breathing in vapours. If the air pollution is above the permitted limit, appropriate respiratory protection is
required.
• Inhalation
Provide affected persons with access to fresh air. Keep the affected person warm and calm. Seek immediate medical attention.
• Ingestion
Rinse thoroughly with water. Move the affected person into the fresh air and place them in warm and calm position that facilitates
breathing. Do not induce vomiting. Never put anything in an unconscious person’s mouth.
• Skin contact
Remove affected person from source of contamination. Medical help should be sought if complaints persist.
• Eye contact
Remove affected person from source of contamination. Remove contact lenses and open eyelids wide. Continue rinsing for at least
15 minutes and seek medical advice.
Warning
Before using your new SQlab grips for the first time, make sure to check the function of the gear and brake levers. If they are not
easily accessible or their function is restricted, please contact your SQlab dealer.
