SPX Waukesha Cherry-Burrell CM, Инструкция по эксплуатации

Страница: 15 / 22

15 95-03028 08/2010
NOTE: Use care at all times to avoid chipping or
scratching seal or seat . Keep seal face areas clean
and dry.
1. Install lip seal (18) into rear of gland plate (17).
2. Apply a small amount of sealant to one end of
each of the six springs (19) and place in gland spring
holes (17).
3. Apply gasket (16) to the sealing face of the gland
plate (17).
4. Attach gland plate (17) to mill body using existing
capscrews.
5. Install one o-ring (24) into groove in mill body.
6. Attach body to bearing case (4 nuts).
7. Lubricate o-ring (24) and small O.D. of seal (20)
with a compatible lubricant and install seal into mill,
aligning notches on the seal with pins in gland plate.
Avoid grease type lubricants which can harden and
bind the seal; use food grade lubricant when process-
ing food products.
8. Lubricate remaining o-ring (24) with compatible
lubricant and install on small O.D. of seat (21).
9. Install seat (21) (with pins and o-ring) into rear of
rotor, aligning pins with holes in rotor.
10. Install rotor onto shaft, being careful to avoid
damage to the seat (21) or seal (20). Tighten rotor
nut to 75 ft-lbs.
11. Complete mill assembly. (Reverse steps 2 and 3
on page 13.)
sanITaRY seal RePlaceMenT
MaInTenance
Figure 22
kIT # 35379+ Convert single spring seal to multiple
spring seal
sanITaRY seal
ITeM
nO.
DescRIPTIOn QTY PaRT nO.
16 Gland Gasket 1 0MS042G00
17 Gland Plate 1 0MS058200
18 Gland Plate Seal 1 0MS030200
19 Spring 6 0MS304200
20
Stationary Seal, Carbon 1 0MS306003
Stationary Seal, Silicon Graphite 1 0MS306004
Stationary Seal, Silicon Carbide 1 0MS306009
21 Rotating Seat, Silicon Graphite 1 0MS014002
22 Capscrew 4 30-98
24
Seal Seat & Body O-ring, FkM
2
V70150
Seal Seat & Body O-ring, Silicone
2
S75150
PL5081-Ch11
PaRTs lIsT