1. Open the drain switch to drain out the water from the cavity into the drip tray. Make
sure the drip tray is inserted into the notch to avoid spilling water on the counter. The
drip tray can hold 15oz (450ml) water so you may need to do this twice.
2. After all the water has drained out, lift the drain switch to closed and put 800ml fresh
water into the cavity.
NOTE: Alternatively, instead of using the drip tray, you may place the drain hole above
your sink or other similar location that allows you to drain all the water at once.
Warning: Clean water is necessary. Make sure the drip tray is inserted into the notch
after draining.
CLEANING BEER TAP MECHANISAM
The Beer cooler hoses should be cleaned often for best results and to avoid any health
hazards. They need to be cleaned before the first use and after long periods of time
between uses. Clean the outside of the machine with dry cloth. Recommended
cleaning steps as follows:
1. Fill the cleaning bottle with warm water.
2. Connect to the end of the piercing pin, squeeze the water into the pin to clean the pin
tube and push the water out from the beer tube. Repeat this until the beer tube is
clean (need 3 bottles warm water at least).
3. Clean the beer tap mechanism as figure 30. Note: Please open the tap when
cleaning. (Show as figure 29)
Figure 29 Figure 30
Warning:
Never put the tap mechanism parts in the washing machine or dishwasher;
Never use a chemical cleaning detergent to clean the parts, warm or purified water is
recommended.
Cleaning
bottle
Beer connector must
connect with dispensing
unit
Please open the faucet when
you are cleaning the beer
tube
Dispensing unit
This connector must connect with
cleaning bottle
