Spreco Silentwind, Инструкция по использованию и установке

Страница: 5 / 21

5
Before you install the windgenerator on a mast construction make sure that the 3-
phase wiring is disconnected from the charge regulator or fix one blade so that the
system cannot turn. You can also connect the 3 AC wires to block the system whilst
mounting. Another possibility to install the system is to screw the hub with the blades
to the shaft at the very end of the mounting procedure. The mast must be well fixed
so that it is safe in strong wind and sea conditions. Please ask a professional who is
able to assess the load that the system generates in strong wind conditions.
2.2. Elecrical risks
An idle running windgenerator can generate an AC voltage of 40 volt AC /15amp per
phase. Only connect all components if you are familiar with electric wiring. The high
voltage can cause serious injuries and fire if you do not pay attention to safety. Never
ever touch the open end of the wires. The currents on charging the batteries can
reach more than 30 A DC. The whole wiring electric components and connection
points must be able to carry a current of 40 A. Find information about suitable cable
dimensions on page 9
Warning :
Wires with insufficient diameters can cause fire.
Make sure that the wires are run so that mechanical damages cannot occur. A
damaged cable is a severe safety risk. Install a fuse to the batteries positive pole as
closel as possible to the battery. In any case a short circuit of the poles must be
avoided.
Warning:
A short circuit can cause fire and explosion. Never ever install batteries where sparks
can cause this risk. Always ensure sufficient ventilation!
The electrical installation should be carried out by persons with suitable skills who
know what they do. Before a storm the Silentwind generator should be manually
stopped with the stop switch on the charge regulator. In case of storms we
recommend to fix one rotorblade to the mast because of the risk of flying objects.