SprayTECH CAPspray CS5100, Руководство пользователя

Страница: 4 / 17

Dual Filtration System
The turbine has two different air filters— one for atomizing air
and one for cooling air. The atomizing air filter is a two-stage,
fine mesh filter designed to trap particles that may damage
your finish. The atomizing air is discharged through the nozzle
of the spray gun where it atomizes the coating material. The
cooling air filter is a coarse mesh filter designed to allow the
proper amount of air flow through the turbine for cooling
purposes. Cooling air is exhausted through the cooling air
discharge on the front of the turbine.
Clean filters regularly. Clogged filters can cause excessive
heat and possibly damage the turbine.
CAUTION
Cooling Air
Intake
Cooling Air Discharge
Atomizing Air
Discharge
Atomizing Air
Intake
4 © 1999 SprayTECH Corporation. All rights reserved.
Maintenance
Use the following procedures to keep your HVLP spray system
running properly.
Cleaning/Replacing the Filters
1. Remove each filter by grabbing them and pulling them
straight out of the filter cans on the turbine. This will not
damage the filters.
2. Clean the filters. Either tap the filters to knock out the
contaminants or use pressurized air to blow out the
contaminants. For material that is not blown or knocked
loose easily, soak the filters in soapy water or minearal
spirits. Allow the filters to dry completely before placing
them back in the turbine.
3. Insert each filter back into its corresponding filter can.
After several cleanings, it may become necessary to replace
the filters. Refer to the parts list near the end of this manual
for the filter replacement kit part number.
Replacing a Fuse
1. Remove the fuse holder cover using a flathead screw
driver. Push the screwdriver into the cover and turn the
cover counterclockwise
2. Pull the old fuse out of the fuse holder cover.
3. Place the new fuse inside the fuse holder cover.
4. Place the new fuse and the fuse holder cover into the fuse
holder. Turn the fuse holder cover clockwise with the
flathead screwdriver to lock it into position.
NOTE: The two-stage, atomizing air filter must be
placed in the filter can labeled “2-Stage Filter”
with the green side facing the turbine.
NOTE: Do not use highly flammable solvents, such as
lacquer thinner, to clean the filters
Cooling Air Filter
Two-Stage Atomizing
Air Filter
(green side facing
the turbine)
English