10
4.1 HOME SCREEN SETTINGS
The home screen at the top and side bars will always be visible and accessible.
Setpoint:
Displays the configurable mode in the application you are set in.
Nozzle status:
Displays the current nozzle spray status as a percentage of the maximum flow rate.
Atomizing air status:
Atomizing Air Status and spray status are read
-
only representations of the current status. Adjust atomizing
air in settings, and toggle the spray status by using the run or trigger buttons.
Spray status:
Shows whether the nozzle is currently spraying or not.
Clean/Purge:
Access or trigger the clean and purge cycle settings.
STANDBY/RUN
Using this Toggle button, you can swap between Run and Standby
states.
•
Run: The system will spray if it is triggered.
•
Standby: The system will stop spraying and will not react to a
new trigger signal.
If the system is busy spraying, it will finish the
“
follower
”
for the air
output to cleanly stop spraying.
TRIGGER
The trigger button is only shown if the trigger source has been set to
“
Button on home screen
”
in
“
Trigger settings
”.
Depending on your settings, you will have:
•
Fixed spray mode, Momentary button (single shot mode): starts a spray when clicked.
•
Variable spray mode, Toggle button: starts & stops a spray when clicked.
4.2 PURGE AND CLEAN SETTINGS
The Purge and Clean cycles can be toggled on or off with their labeled On/Off indicators at the bottom of the screen. A
blue indicator with the dot on the right
-
hand side shows the currently selected and active cycle.
PURGE
The purge cycle is used to empty the fluid lines of liquid, or as an additional way to drain a tank or pressure pot.
The purge cycle automatically sets the nozzle duty cycle to 100% (fully open) and requires the operator to manually
turn the cycle on or off using the labeled indicator. The cycle will continue until it is manually turned off. The other
values are not editable while the purge cycle is active.
CLEAN
The clean cycle is commonly used to clear a nozzle that appears to
be clogged and requires the operator to set three editable values.
These values include:
•
Clean Duty Cycle —
Set between
1
–
100%
•
Max Cycle Speed —
Set between
60
–
5,000
cycles/minute
•
Clean Time —
Set between
1
–
250
seconds
1750+ Home Screen
SECTION 4
1750+ HOME SCREEN
Purge and Clean settings screen
