13
Place the Seat (9) onto the Main Frame (3), align the Main Frame (3) bolt holes to the
holes of the two washers (14) attached to the Seat (9). The sitting pad should be
positioned above the Base Frame (4) as shown in the illustration above.
Proceed to install a Washer (12) on the corresponding Bolt (13) for this step.
Slide the Bolt (13) through the holes mentioned on point
A)
.
Install another Washer (12) on the opposite side of the Bolt (13).
Install the Nylon Nut (15) on the headless side from the Bolt (13) where you just added
a Washer (12).
Proceed to tighten, utilizing the two wrenches. Rotating clockwise on one side and
holding firmly on the opposite side of the Bolt (13), in order to facilitate the tightening
process.
Now the Seat (9) should be securely attached to the Main Frame (3).
A)
B)
C)
D)
E)
F)
E)
INSTRUCTIONS
(15)
NYLON NUT M10 (1 PC)
(12)
WASHER Ø10 (2 PCS)
(3)
MAIN FRAME
(9)
SEAT
(13)
BOLT M10X100
(1 PC)
(12)
The following parts are needed in this step.
STEP 5: ASSEMBLING THE SEAT
