SportsPlay QUICK SHIP 1 MODIFIED, Руководство по установке

Страница: 43 / 112

March 10, 2014 5
922-126-3 (3’) TRIPLE RAIL SLIDE
INSTALLATION INSTRUCTION
SPECIFICATIONS

Slide – 3/8” walled rotationally molded LLDPE

Paint – Electro statically applied & oven cured powder coat

Hardware – Stainless steel & tamper resistant

Tube – FloCoat® Galvanized 1 3/8” OD and 1” OD.

Attachment Bracket – Powder coated cast aluminum
SPECIAL SAFETY & ASTM COMPLIANCE NOTES

ASTM F1487 5.5.2 the run out slope of slide exit region
must be between 0 and -4 degrees.

ASTM F1487 8.5.5.3 For slides with an elevation of no
greater than 48 in., the height of the exit region shall be no
greater than 11 in. above the protective surfacing. For
slides with an elevation greater than 48 in., the height of the
exit region shall be between 7 in. and 15 in. above the
protective surfacing.
INSTALLATION TIPS & TROUBLE SHOOTING

SportsPlay Equipment Inc. recommends pre-drilling the
holes in the post when attaching a four-hole bracket with a
number #7 drill bit. This will make the attachment of the
four-hole bracket with the self-tapping screws easier and it
will prevent damage to the screw head during installation.

Apply locktite to all bolts during assembly prior to
completely tightening them.

Stainless Steel hardware can occasionally be difficult to use
particularly if you need to take them out to make an
adjustment. It is recommended that you add a drop of oil to
bolts that may have to be removed before you install them.

Do not tighten bolts all the way until the unit is completely
assembled and all components are square and level.

Identify and separate all parts by referencing the detail
drawings and the parts list.

As you unpack and separate the components use the
cardboard sheets that were used for packing and shipping to
prevent damage to the components. This is particularly true
all Powder Coated and Thermoplastic coated components,
by setting the components on top of the cardboard.