WWW.SPORTDOG.COM
17
3. Program the first Collar Receiver:
A.
Turn the Collar Receiver off.
B.
Press and hold the On/Off Button. The Receiver Indicator Light will come on, then turn off in
4-5 seconds. If the On/Off Button is released too early, the Receiver Indicator Light will begin
its normal flashing. If this occurs, start over and repeat from
A
.
C.
After the Receiver Indicator Light has turned off, release the On/Off Button.
D.
Press and hold the
Upper Button
on the Remote Transmitter until the Receiver Indicator Light
flashes 5 times. If the Receiver Indicator Light does not flash 5 times, start over and repeat
from
A
.
4. Program the second Collar Receiver using
A
through
D
above, but using the
Lower Button
in
place of the Upper Button.
5. Program the third Collar Receiver using
A
through
D
above, but using the
Side Button
in place of
the Upper Button.
SIX DOG OPERATION
Program the Remote Transmitter to mode 3 in the toggle switch
up
position (see page 14).
For six-dog operation repeat above Steps 3-5 with the toggle switch in the
up
position for dogs 1-3; then flip the
toggle switch to the
down
position, and repeat above Steps 3-5 for dogs 4-6.
STEP :: 09
CHANGE ID CODES
An ID Code is the signal identification between the Remote Transmitter and Collar Receiver. Each is programmed
in 1 of 2,000 ID Codes from the factory. The SportHunter
®
1825 has the flexibility to program two or more Remote
Transmitters to the same ID Code, allowing them to both control one Collar Receiver. There are 64 programmable
ID Codes available.
TO MANUALLY PROGRAM THE REMOTE TRANSMITTER’S ID CODE FOLLOW THESE STEPS:
1. Turn the Intensity Dial to level 8, flip the toggle switch up, and then press and release the Mode Button
on the back of your Remote Transmitter. This does not change the mode, so the current mode will still
be active after the ID change is complete.
2. Once the Mode Button is released, the Transmitter Indicator Light will illuminate solid green and stay
on for 15 seconds.
3. While the green Indicator Light is on, turn the Intensity Dial to select the 1st digit of the ID, and then
press and release the Side Button. The green Indicator Light will flash rapidly confirming selection.
4. Again, while the green Indicator Light is on, turn the Intensity Dial to select the 2nd digit of the ID,
and then press and release the Side Button. The green Indicator Light will flash rapidly confirming
selection. The 2nd digit is optional, and if not desired, just wait until the green light turns off and refrain
from pressing the Side Button.
5. At the end of 15 seconds, or after the second press of the Side Button, the green Indicator Light will
turn off and the ID of the unit will be updated. At this point, the unit will be in the same mode it was in
prior to setting the ID.
6. Upon changing the ID Code, you will need to match the Collar Receiver to the Remote Transmitter (see
STEP 6 on page 16).
NOTE: If you press the Side Button only once (skipping Step 4) the ID is still a two digit ID. The left digit is
defaulted to 1. For example, if you selected 6 in Step 3 and pressed the button only once, the ID you get will
be 16.
