| 7
EN | instructioni
8. CONTROL PANEL
BASIC INFORMATION
STARTING AND ENDING WORKOUT
• To start the training, press the START/STOP but-
ton on the console.
• The track will begin to move within 5 seconds
of pressing/clicking the Start button.
• You may end the workout (stop the track)
at any time by pressing/clicking on Stop.
• The track will also stop when the safety key
(emergency stop) is disconnected from the
control panel.
SETTING THE SPEED / INCLINATION ANGLE
To change the inclination angle of the treadmill
belt, press the
I/-
button on the con-
sole handle.
To change the speed, press the
SPEED +/-
but-
tons on the console handle.
Speed adjustment range: 1-16km/h
Adjustment range of the running belt inclination
angle: 15 levels
PULSE MEASURE
The track is fitted with sensors that allow you to
measure your pulse by hands. To check your pul-
se, put both hands on the handles. The read will
appear on the screen in about 5 seconds.
To measure the pulse rate correctly, do this when
the track is stopped, holding the hands on the
sensors for at least 30 seconds.
Note:
The data shown is generic, provided for
comparison of different training sessions. It sho-
uld not be used for medical purposes.
SAFETY KEY
A safety key is intended to deactivate the tread-
mill immediately if you fall down. It serves as an
emergency stop. The safety key must be used in
urgent cases only.
For safe and convenient stop, use START/STOP
button until the treadmill stops completely. Once
you have pressed START/STOP, the treadmill belt
will gradually decreased its speed. The treadmill
will not activate until you have inserted the safety
key in the key hole located in the centre of the
counter control desk, which provides additional
protection to treadmill activation by third parties.
The other end of the key must be attached to
clothes. If you fall down, the safety key will fall
out the control desk and the treadmill will stop
immediately. Use only in urgent situations
IN ORDER TO PREVENT ANY INJURIES DURING LI-
FTING OR SETTING THE TREADMILL BE SURE YOUR
GRIP IS FIRM AND STABLE.
ATTENTION:
Folded treadmill cannot be opera-
ted and utilized. Stop the treadmill belt before
folding the equipment. Folded treadmill should
be disconnected from power supply. Don’t start
the treadmill when it’s folded.
To move the treadmill, raise it gently onto the rear
transport rolls and move it to the desired location,
holding on both sides.
ATTENTION:
Before transporting the treadmill
make sure that it is disconnected from power
supply. The device should always be transported
by two persons.
