•
The Control Panel has three main controls; Push Buttons (A), Knobs (B) and the Program Dial (C).
−
To remove a Push Button (A), first mask the area to protect against damaging the Control Panel, then carefully insert a small
screwdriver between the bottom of the Button and the Control Panel (Fig. 4-2), now pry the Button out and off.
−
To remove the Knobs (B) or the Program Dial (C), grasp the firmly and pull straight out toward you.
A
Fig. 4-2
REPAIR MANUAL
Page: 4
4. CONTROL PANEL COMPONENTS - Switches and Potentiometers
Fig. 4-1
B
C
•
To remove either the Switches (A) or the Potentiometers
(B), first remove the Button and/or Knob. The Switch and
Potentiometers are held in place by four (4) positioning tabs
(Fig. 4-3). Using a small screwdriver press the tabs inward
then slide the Switch or Potentiometer out from the rear of
the Control Panel.
•
On both Fig. 4-4 Switch and Fig. 4-5 Potentiometer you can
see the positioning tabs.
TECH NOTE: The tabs on the Switches and Potentiometers
are very delicate and can easily snap off.
Use care when removing or replacing.
Fig. 4-3
B
A
A
Fig. 4-4
Fig. 4-5
AW 120 / AW 122 / AW 125
AWD 120 / AWD 121 / AWD 129
