TSL.R.030 RIBBON HAND DRYER MANUAL 19
Corrective Actions for Initial Installation Failures
If the dryer will not run:
+
First ensure that the breaker supplying the dryer is operational. If it is, disconnect
the power and remove the dryer cover. Replace the CBM and IR sensor module.
Taking suitable precautions to avoid shock hazard, reconnect the power and
check for Voltage at the terminal block.
The IR sensor only sees close range objects:
+
Ensure that there is no obstruction on or in front of the IR sensor. Clean any dirt
or debris off the sensor lens. Check variable resistor for sensor range setting, If
problem persists, disconnect the power and remove the dryer cover and replace
CBM, IR sensor module.
The heater gets hot but no air stream is produced:
+
Disconnect the power. Remove the dryer cover. Check variable resistor for speed
setting Disassemble the blower- motor/ fan housing. Replace the fan motor.
Reassemble.
