25
General Maintenance
1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of two
reasons:
i.
The hardware was not sufficiently tightened during assembly. All bolts that were installed
during assembly need to be tightened as much as possible. It may be necessary to use a
larger wrench than the one provided if you cannot tighten the bolts sufficiently. l cannot
stress this point enough; 90% of calls to the service department for noise issues can be
traced to loose hardware or the rear rails being dirty.
ii.
Dirt build-up on the rear rails and polyurethane wheels are also a source of noise. Noise
from build-up on the rails can cause a thumping sound that you would swear is coming
from inside the main body of the machine because noise travels, and is amplified, in the
tubing of the frame. Clean the rails and wheels with a lint free cloth and rubbing alcohol.
Stubborn build-up can be removed with your thumbnail or a non-metallic scraper, like the
back edge of a plastic knife. After cleaning, apply a small amount of lubricant on the rails
with your fingers or a lint free cloth. You only need a thin coat of lubrication, wipe off any
excess.
3. If squeaks or other noises persist, check that the unit is properly leveled. There are 4 leveling
pads on the bottom of the rear rails, use a 14mm wrench (or adjustable wrench) to adjust the
levelers.
ENGINEERING MODE MENU
The console has built in maintenance/diagnostic software. The software will allow you to change
the console settings from English to Metric and turn off the beeping of the speaker when a key is
pressed for example. To enter the Engineering Mode Menu, press and hold down the
Start
,
Stop
and
Enter
keys. Keep holding the keys down for about 5 seconds and the Message Center will
display Engineering Mode Menu. Press the
Enter
button to access the menu below:
a. Key Test (Will allow you to test all the keys to make sure they are functioning)
b. LCD Test (Tests all the display functions)
c. Functions (Press
Enter
to access settings and
Up
arrow to scroll)
i. Sleep Mode (Turn on to have the console power down automatically after 20 minutes of inactivity)
ii. Pause Mode (Turn on allow 5 minutes of pause, turn off to have the console pause indefinitely)
iii. ODO Reset (Resets the odometer)
iv. Unit Type (
Press enter to select ENGLISH or METRIC
)
v. Beep (Turns off the speaker so no beeping sound is heard)
vi. Motor Test (Press
Enter
to run the resistance motor up and down in a continuous loop. Display
shows level setting and position sensor reading. Press
Stop
to end test.)
vii. Safety
viii. Elliptical/
e
‧
Glide
ix. Incline On/Off (For e Glide this is always off)
‧
d. Security (Allows the keypad to be locked to prevent unauthorized use)
Incline Calibration:
If there is a problem with the incline, try running the calibration. Press the Start key,
Level up key & Stop key at the same time. Hold them down for 5 seconds and the Incline calibration will
star t and run automatically. If the problem persists, contact service department.
Содержание XE395 ELLIPTICAL SPT0065
Страница 7: ...6 ...
Страница 27: ...26 Exploded View Diagram ...
