8
STEP 2:
Connecting & Lower Swing Arms
1. Slide two Wave Washers
(150)
onto each side of the Swing Arm Axle. Slide the Lower Swing Arms (
10
Left,
11
Right) onto the axles and secure with the two
Hex Head Bolts
(184)
and Flat Washers
(141)
.
Do not force the Swing Arms onto the axle. They should slide on, but you may need to jiggle them to
get them lined up properly. The Swing Arms have been previously installed at the factor y so they do fit
properly.
2. Remove the tie that holds the spacer in the rod end located at the end of the Right Connecting Arm
(9)
and line up the rod end with the bracket at the bottom of the Lower Right Swing Arm
(11)
. Slide the
Hex
Head Bolt
(186)
through the bracket of the Lower Swing Arm and then through the rod end and spacer.
Install the Flat Washer
(142)
and Nyloc Nut
(192)
on the bolt and tighten as much as possible. Repeat
this step for the left side. Tighten using the Wrenches (
155
&
158
).
HARDWARE
#150.
Ø
17 m/m
Wavy Washer (4 pcs)
#141.
5/16" × 23 × 1.5T
Flat Washer (2 pcs)
#142.
5/16" × 20 × 1.5T
Flat Washer (2 pcs)
#186.
5/16" × 1- 1/4"
Hex Head Bolt (2 pcs)
#192.
5/16" × 9T
Nyloc Nut (2 pcs)
#184.
5/16" × 15mm
Hex Head Bolt (2 pcs)
Содержание XE395 ELLIPTICAL SPT0065
Страница 7: ...6 ...
Страница 27: ...26 Exploded View Diagram ...
